We use
cookies
on this site
Log in
Home
Home
Downloads
Forms
M1 Firmware
Packages
Help
< GPR (M150).November 2013
Package GPR (M150).November 2013 "Coyote Stock Injectors"
Firmware
GPR (M150).November 2013
Comment
Coyote Stock Injectors
Licence
GPR (M150).November 2013
Firmware Version
01.00.0005
Upload Date
6/02/2014
Release Notes
Current Version
Update GPS module to 01.05.0008
Bugfix where downshift throttle blip does not cancel
Bugfix: Calculation of Fuel Injector Duty Cycle now only based on enabled cylinders.
Fuel Cylinder N Output Enable is set to Disabled if the Cylinder No > Engine Cylinders.
Fix idle mass flow calculation when steering pressure senor is disabled.
Idle request: add Throttle Aim State 'Pedal' to entry conditions.
MAP estimate calibration method uses Airbox Pressure and Ambient Pressure fall back, equal to MAP Estimate calculation.
Knock Warning only consideres active cylinders.
Remove Charge Cooling Gain Max validation.
Add Engine Speed axis to Engine Boost Limit table.
Documentation updates.
01.00.0003
Turn off 300kPa manifold pressure limit.
Turn off 15000rpm engine speed limit.
Fix gear ratio calculation causing incorrect traction control and vehicle speed limit operation.
Clamp 'Idle Mass Flow' channel to the range [0, 100]%.
Increase knock calculation rate to 200Hz to give finer resolution on 'Knock Activate Delay'.
Report overrun, overboost and flood clear as 'Fuel Cut' rather than a generic fuel disable.
Ignore 'Air Conditioner Refrigerant Pressure' sensor if it is not in use.
Add 'Coolant Temperature Estimate' table.
Run coolant fans continuously if coolant temperature sensor fails.
Add 'ECU Power Relay'.
Add 'Steering Pressure Switch'.
Documentation updates.
1.00.0002
Initial release.
Related Software
Minimum M1 System Version
01.03.16.0057
Minimum M1 Tune Version
1.3.3.177
Versions
Version
01.00.0003
01.00.0005
01.00.0006